Automatic partition assembler machine manufacturer

What is the working principle of the high-speed automatic partition assembler equipment?

1. The warp and weft slicing insertion system and the warp and weft slicing insertion port of the high-speed grid inserting machine are installed at the middle and front ends of the left and right wings of the rack, the weft slicing entry port is installed at the left end of the rack, and the exit port is located at the right end. Put the weft yarn and weft piece into each feed hopper by hand.

2. One by one, the chip wheel is fed into the clip on the clamp chain at intervals. When the chain clamp operates intermittently, the shedding device will open automatically, and the warp and weft yarns will run to the positioning intersection point at intervals at the same time. The CNC eccentric wheel gives the thrust to insert the warp into the weft mouth for matching, thus forming a checkered product. The products in the clamp run on the assembly line in turn and circulate to the outlet at regular intervals. The finished product in the fixture is pushed out of the fixture by the CNC eccentric wheel and counted by the counter.

What are the correct operating procedures for the high-speed automatic partition assembly machine?

1. The corrugated carton partition assembly machine must be operated by professionally trained staff according to the operating procedures.

2. Ensure that the mechanical moving parts are well lubricated.

3. All fasteners must be connected reliably.