The standard practical operation of the Automatic carton printing die cutting slotting machine. At this stage, most of the printing equipment uses the water tank for immediate power supply. The water mobility is achieved by the pressure difference. A moderate pressure difference can maintain the power supply uniformity, so it is necessary to establish the standard for the occurrence of pressure difference. Do not fill the water tank when filling it to prevent negative pressure. The water should not be dirty. In addition, pay attention to the good sealing of the water filling hole on the water tank. If the sealing is not suitable, the water flow will be unstable. After the water in the water tank is used up, the residual liquid in the water tank should be washed clean and then filled with new fountain solution.

In addition to the immediate power supply of the water tank, some equipment at this stage also uses electric water drainage, that is, the water in the water tank is sent to the Automatic ink flexo printer die cutting slotting machine according to the water pump. This method can cycle the power supply of the system, but in order to prevent dirt from entering the ink printing slotting machine again, so the filter device is equipped at the population of the centrifugal pump, and the filter device should be cleaned regularly. There is also a power supply method that is ethanol wetting. According to a water tank, send the fountain solution to each color deck. Pay attention to the mixing ratio of alcohol and water, which is generally 25%. At the same time, pay attention to the room temperature should not be too high, otherwise alcohol volatilization is serious.

If you are also interested in this machine,please don’t hesitate to contact us:

Overseas manager: Tom Wang

Email:cartonmachine.tomwang@aliyun.com

Phone/Wechat/Whatsapp:+86 13303078975