The machine and equipment in the production process is the ink printing slotting equipment. However, there are many complicated processes in the production and processing of paper boxes. Therefore, many ink printing machine parts will also be used in this process, including a device for packaging and printing. What common faults usually occur in the whole process of packaging and printing of the ink press packaging and printing group?

1: Packaging and printing run.

If this common fault occurs in the packaging printing group of the ink press, it is likely to be caused by the following reasons: the press roller is not clamped or the part is not suitable, the press roller and the packaging printing barrel are not aligned, the printing plate is not hung tightly or loose, the printing plate is worn out due to long-term application, and the width of the hard board is very small.

The relative treatment measures are to adjust the working pressure and position of the press roller, adjust the flatness of the press roller and the packaging printing barrel, tighten the ratchet wrench on both sides of the hanging plate to make the printing plate tight, disassemble and replace the new printing plate, and use the appropriate cardboard width.

2: Water ripple.

In the whole process of production and manufacturing, if it is found that there are water streaks in the packaging and printing group of the ink press, it may be caused by the slow speed of the equipment or the slightly low concentration value of the ink brush. It can speed up the equipment speed or ink concentration value to deal with this posting problem.

3: White leakage in packaging printing.

The packaging and printing white leakage of the packaging and printing group of the ink press may be caused by the poor contact between the anilox roller and the printing plate, the unfitness of the press roller and the packaging and printing drum, the damage of the printing plate gasket, and the rapid drying of the ink brush. Therefore, it is necessary to adjust the anilox roller and the printing roller, adjust the bottom roller and the printing roller, remove and replace the new gasket, add the slow drying agent to the ink brush painting or remove and replace the ink brush painting.

First of all, before announcing the application of the flexo printer die cutting slotting machine, that is, before starting, a simple query should be carried out on the gearbox of the carton printing machine. When the gearbox is reset to zero, the equipment can be turned on and off to run the startup procedure. The purpose of that is to prevent the automatic startup after startup. When the speedometer is not reset to zero, the start will start automatically, which is very easy to cause no damage.

Secondly, before starting, also pay attention to whether there is too much ink on the rubber plate of the carton printing machine and its level of detail. If there is too much ink or damage to the rubber plate, the actual effect of packaging and printing of the paper box will be greatly affected. Once the two conditions are found, immediately carry out the change. After checking the rubber plate, pay attention to check whether several equipment of the printing equipment are assembled and tightened.

Check the clearance between the rubber shaft and its anilox roll. Before using the carton printing machine, the user should pay attention to the length of the gap between them to prevent ink blocking in the whole process of packaging and printing, which is not only very easy to cause consumption but also harmful to the packaging and printing level of the carton.

Before application, in order to speed up the operation of the carton printing machine and the muscle strain level of the parts, the user can properly add some automobile oil to the  automatic flexo printing die cutting slotting machine after all inspections.

If you are also interested in this machine,please don’t hesitate to contact us:

Overseas manager: Tom Wang

Email:cartonmachine.tomwang@aliyun.com

Phone/Wechat/Whatsapp:+86 13303078975